| | |  | 4 - Articulating & Cantilever | Home » » » » Vantage Point AX2AWL01S Articulating Wall Mount for | | | | | | | Description: | | The Axsys articulating wall mount is designed to support LCD monitors which are VESA 100mm and 200mm mounting patterns and will support monitors up to 100lbs. The unique design allows for easy install and is allows for a 5 degree adjustment range to the left or right on the wall mount base ensuring a perfectly level install every time. The mount is adjustable with a tilt of 5 degrees up and 15 degrees down for a precise viewing angle. The mount is also adjustable in a 180 degree side to side swivel from the wall. The Center Channel speaker mount, AX2LSB01S is perfect for use with this monitor mount in any home theater application. | | | Features: | |
• Designed to complement your home's appearance
• Mount is designed to fit 100- and 200-millimeter VESA mounting patterns on LCD monitors
• 180-degree rotation for precise viewing
• Adjustable tilt up and down for greater viewing comfort
• Supports monitors weighing up to 100 pounds
| | | Product Details: | | | Product Length:
| 15.0 inches | | Product Width:
| 4.0 inches | | Product Height:
| 13.0 inches | | Product Weight:
| 9.0 pounds | | Package Length:
| 16.1 inches | | Package Width:
| 13.0 inches | | Package Height:
| 4.2 inches | | Package Weight:
| 10.05 pounds | | Average Customer Rating:
|  based on 6 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 6 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
6 of 6 found the following review helpful:
 Articulating Arm ReviewSep 08, 2005
By Ellen J. Jurczak
"frankthecat"
The wall mount is fine but was somewhat difficult for one person to install - the TV is difficult to attach. Also, it wasn't described very well and the dimensions were not included. I didn't know how it was going to fit or work until I received it. It would also be nice if there was some way to attach the TV cables to the arm or route them through the arm so they don't show. Now that I have mounted it, I like it.
4 of 4 found the following review helpful:
 Excellent ProductDec 27, 2006
By aje3892
"Adam"
I just installed this about 4 hours ago. It took me an hour, even with my drill's batteries needing a charge. The trick is to follow the instructions. I looked around at many wall mounts and this was the best choice. It is recommended to mount it into a stud. Luckily in order for it to be centered on the wall I needed a stud approximately 16 inches to the left/right, and there was one there. It gives you offset holes to screw into a stud if you absolutely need it to be in a particular location.
Process:
1 - Find Stud/Location to hang wall mount
2 - Place wall mounting bracket on the wall and mark drill hole.
3 - Using a 3/16" drill bit drill about 1 1/2 inches into the stud
4 - Screw long wood screw into the wall bracket/stud using a low speed drill.
5 - Approximately level vertically using a bubble level. Mark slotted hole and drill 3/16" hole again 1 1/2 inches deep into the stud.
6 - Screw long wood screw into the wall bracket/stud using a low speed drill until there is just enough play to move the bracket so it can be leveled finally.
7 - Level wall bracket vertically using level and tighten both screws.
8 - Finish inserting the last two screws.
9 - Follow the instructions on the sheet for the rest. Be sure to install the break mechanism that is supplied with the device. It really works well and you can tighten the stiffness of both arms.
I left the front tilt screws just loose enough that I can place the LCD at any tilt without it falling all the way forward. I used a level to level the LCD horizontally and tightened those screws pretty good so it wouldn't lean on me.
It looks great and I can sit in my kitchen and pull it from the wall and angle it towards me, or I can sit on the couch and have it tight against the wall.
I'm going to look into zip tying the wires to the arm.
2 of 2 found the following review helpful:
Works for meJul 27, 2006
By Tyler Forge
"realist"
Simple and does the job. No surprises. I had no trouble setting it up by myself. The trick is putting the TV on the arm before putting the arm into the wall mount. Gravity does all the work that way.
1 of 1 found the following review helpful:
 Good quality, but poor instructions for mountingFeb 13, 2009
By That Lake Girl
"h2oorsnowski"
Constrution of this TV mount seems good and it is sturdy. The instructions for mounting are very poor (this coming from an engineer's viewpoint). Make sure you will be able to mount to a stud before purchasing this product. Once it was finally on the wall, we were pleased with the performance. It has many easy adjustments for different viewing angles. Also, it is sometimes difficult to tell from the verbage, but it is compatible with 200x100 VESA configuration.
Good quality, simple installation, very affordableDec 05, 2009
By William Smith
I'm very pleased with this mount. Installed it myself, which was incredibly easy, only took 10 minutes. I mounted a 32" Samsung, and now I have more room on my dresser! i high recommend this mount!
See all 6 customer reviews on Amazon.com
| | |
|
